The MUSOTOKU Power Supply is an extra injection of power to your machine during 0.5 seconds after pushing the foot switch.
This pulse will make your machine to start up always, no matter if speed is very low or ink is too sticky.
No need to prod the spring-clip with your finger anymore, or increasing the speed of your rotary to make it works.
Using MUSOTOKU is better for the health or your rotary and coil machines: no stall, less heat and full control.

SETUP MEMORIES:
x4 Setup Memories for your machine. Do everything with a single pushbutton, no complications.
Readjust on the go, and it will be automatically recorded for you. Simple.

ANALOG & DIGITAL:
The unbeatable touch of analog dial, but with the accuracy of digital control.
We love it because the dial spin is endless and gives you 0.1V for each rotation click.

POWER:
Forget about heat in your Machine, and stay always cool.
Keep your machine at a consistent speed.
Stable under any load condition with no speed fluctuations thanks to the 5A capability.

FEATURES:
+ Output Current 5A (10A peak)
+ Output Voltage 2 to 16V
+ Digitally Adjustable in 0.1V Steps
+ Adjusting dial with infinite turns
+ 4 auto-record Memories (Non-Volatile)
+ NITRO Startup Pulse Configurable
+ Overcurrent Protection (3 types)
+ Pedal Push detection (LED)
+ x3 Pedal Modes: Normal, Maintained, One-Touch
+ Standard Foot-Switch Input 1/4? Jack
+ Standard Clipcord Input 1/4? Jack
+ Input 19V (Universal wall adapter)
+ Dimensions 116×72 mm
+ Weight 169 gr only
+ Material: Aircraft grade Aluminum
+ GoPro Mounting compatible